Printronix T3204 series Operator's Manual page 21

g Route the media liner (backing)
around the tear bar to the media
rewinder.
h Place the clasp over the end of the
media, and rotate the media
rewinder a few turns.
i
Rotate the media guide up, and slide
it to the media's edge.
j
Lift and snap the lower right front
panel closed.
k Raise the hinge plate, and latch the
printhead by rotating the printhead
latch clockwise to the latched
position.
l
Close the side cover.
It is possible to use the present
sensor only (without inverting the
tear bar) to provide on-demand
label printing in the tear -off mode.
T o operate in this mode, media
should be routed as shown in
step f, and the Label Present
menu selection should be
enabled.
Operator' s Guide
note
loading media
13