Table of Contents
Advertisement
10
If the media you are loading is of the
same width as the current media, skip
the next step and go on to
11
If you are loading media that is of a
different width from the current media,
you may need to adjust print quality as
follows:
The printer is aligned at the factory with
4–mil–thick label stock, whose width is
the maximum width accepted by the
printer.
a Raise the hinge plate, and lower the
printhead by rotating the printhead
latch clockwise to the latched
position.
b Press ON LINE/PAUSE to enable
printing.
c Send a sample test print file from the
host, or run the internal diagnostic
test file.
It may be necessary to feed several
labels before proper alignment of the
media occurs.
d If the print quality is acceptable, go
on to
step
e Otherwise, press ON LINE/PAUSE
again to place the printer in the off
line mode.
Although the head leveling knob can be
adjusted during printing, it is
recommended that this adjustment be
done while the printer is paused.
Operator' s Guide
step
note
note
12.
note
12.
Printhead
Latch
loading media
Media
Hinge
Guide
Plate
9
Advertisement
Table of Contents
