removing the ribbon
6
Slide the used ribbon off the hub, and
dispose of it.
7
Turn the ribbon supply hub clockwise to
draw the unused portion of the ribbon
back onto the supply roll.
You may leave the unused portion of the
ribbon in place until the next thermal
transfer print job, at which time you may
reinstall it by following the ribbon
installation procedure.
8
Raise the hinge plate, and lock the
printhead by rotating the printhead latch
clockwise.
9
Close the media supply door.
1
Press ON LINE/PAUSE to enable
printing.
22
note
Printhead
Latch
Operator' s Guide
Hinge
Plate