Printronix T3204 series Operator's Manual page 19

13
To use the media rewind hub, complete
the following procedure.
a Lower the lower right-hand front
panel.
b Remove the arc plate from its stored
position, and install on the front of
the printer.
Route the media around the arc
plate and to the media rewinder.
c Place the clasp over the end of the
media, and rotate the media
rewinder a few turns.
Rotate the media guide up, and slide
it to the media edge.
d Lift and snap the lower right-hand
front panel closed.
Continue with step 14.
14
Raise the hinge plate, and lower the
printhead by rotating the printhead latch
clockwise to the latched position.
15
Close the media supply door.
16
Press ON LINE/PAUSE to enable
printing.
It may be necessary to feed several labels
before proper alignment of the media
occurs.
Operator' s Guide
note
loading media
11