802.11 Control; 802.11 Network - AJA Ki Pro Installation And Operation Manual

54

53.1 802.11 CONTROL

53.2 802.11 NETWORK

53.1 802.11 CONTROL
This parameter determines whether Ki Pro can be controlled remotely from a wireless
browser. Enabling 802.11b/g control turns on the internal 802.11 radio. Parameters
53.2 through 53.5 must be set correctly to configure Ki Pro so it can be controlled. Ki
Pro wireless control also requires the presence of wireless access point on the local
LAN that it can communicate with.
Note: Although Ki Pro has an internal 802.11 transceiver, it is not a wireless access point.
Wireless browser clients talk to Ki Pro via an external wireless access point (such an
Airport Extreme base station). Also, turning on the 802.11 radio consumes additional
power; it should be disabled unless needed in order to save battery life.
DISABLED (default)
ENABLED
Caution!
The 802.11b/g radio is disabled by default and can be enabled only in the
presence of an authorized access point.
Controlling Ki Pro from a browser (wired or wireless) is described in
Chapter 4, Remote Web Control. As an overview, to wirelessly connect Ki Pro, you
must:
•
Enable the radio (53.1)
•
Define the security between Ki Pro and wireless browser clients via parameter 53.3
•
Setup the correct password required for wireless browser clients via parameter 53.4
•
Choose the wireless access point that will connect Ki Pro to the LAN and to wireless
browser clients (54.1 through 54.3). The access point will have a 802.11b/g network
name defined.
53.2 802.11 NETWORK
This parameter defines the wireless network or "SSID" that Ki Pro will connect to via
the access point.
variable
Disable wireless control of Ki Pro
Enable wireless 802.11 control of Ki Pro
Using the adjust buttons, enter a legal wireless network
name (SSID) for Ki Pro to connect with. Using the adjust
buttons and the top Select button, select the characters
for the password. The adjust buttons scroll through the
choices and the top Select button advances to the next
character. While selecting characters, the character being
changed will flash to show its position. The character set
allowed is:'-','.', A through Z (uppercase) and a through z
(lowercase).