Connections; Transmitter Connections - Extron electronics DTP HDMI 230 User Manual

Hdmi twisted pair extender
Hide thumbs Also See for DTP HDMI 230:
Table of Contents

Advertisement

Connections

Transmitter Connections

Figure 2.
a
b
c
d
DTP HDMI 230 Tx Rear Panel
INPUTS
POWER
12V
AUDIO
0.7A MAX
5
2
1
DTP HDMI 230 Tx Connectors
HDMI input connector — Connect an HDMI cable between this port and the HDMI
output port (or DVI port, with an appropriate adapter) of the digital video source.
Audio input connector — If desired, plug an analog audio input into the transmitter
via this stereo mini jack connector.
NOTE: The analog audio input on this connector is in addition to the digital audio
that may be embedded in the HDMI input. See the
figure at right to identify the connector tip, ring,
and sleeve when you are making connections for
the transmitter from existing audio cables. A mono
audio connector consists of the tip and sleeve. A
stereo audio connector consists of the tip, ring,
and sleeve.
RS-232 and IR connector — Connect a serial RS-232 signal, a modulated IR signal,
or both to this 3.5 mm, 5-pole captive screw connector for bidirectional RS-232 and
IR communication. See
RS-232 and IR connector wiring
connector.
DTP Output RJ-45 connector — Connect one end of a TP cable to this RJ-45
female connector on the transmitter. Ensure the opposite end of this cable is connected
to the receiver DTP Input RJ-45 connector (see
ATTENTION:
Do not connect this device to a computer data or
telecommunications network.
TP cable termination
NOTE: See
connectors and for detailed NOTES.
Signal LED — This LED lights when the unit is receiving a TMDS clock signal on the
HDMI input (transmitter) or any valid signal on the DTP In connector (receiver).
Link LED — This LED lights when a valid link is established between the units on the
DTP input and output cable.
DTP HDMI 230 Tx/Rx Transmitter and Receiver • Installation and Operation
OVER DTP
SIG
LINK
RS-232
IR
Tx Rx
G
Tx Rx
DTP OUT
4
3
3.5 mm Stereo Plug Connector
f
item
on the next page).
on page 7 to properly wire the RJ-45
Tip (+)
Ring (-)
Sleeve ( )
(balanced)
on page 10 to wire the
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dtp hdmi 230 txDtp hdmi 230 rx

Table of Contents