Extron electronics DTP HDMI 230 User Manual page 19

3. Locate, lift off, and discard jumpers JMP2 and JMP3 from both units (see figure 13).
JMP3, JMP2
Transmitter
Figure 13. Jumper Locations
4.
Reinstall the covers on both units, securing them in place with the screws removed in
step 2.
5. Reinstall both units in their racks or other installation option (see
Transmitter and Receiver
6. If you are using shielded cable, disconnect the cable shield from the connector at
either end of the cable.
7. Obtain a second 12 V power supply (one supply is provided with the transmitter and
normally powers both units), and locally power both units (see
on page 9).
DTP HDMI 230 Tx/Rx Transmitter and Receiver • Reference Information
Receiver
on page 11).
JMP2
JMP3
Mounting the
Power supply wiring
13