Using The Program - Extron electronics FOX DA8 Plus User Manual

Using the Program

NOTE:
1
Figure 8.
Activating a USB port for the first time
The first time you connect to the Configuration (USB) port, the Found New Hardware Wizard
appears (figure 8). Activate the connected USB port for your device as follows:
NOTE:
1. Select the
2.
Select the I
Follow the on-screen instructions. The wizard assigns the driver necessary to access the
DA to the connected Configuration (USB) port (this may take a few minutes).
3.
Click
Finish
4. Proceed to
Instruction Set™
NOTE:
The first time you connect to the Configuration (USB) port, the Found New
Hardware Wizard appears (see
first time," below.
For other connections, proceed to "Starting the program," on the next page.
1
Found New Hardware Wizard
If you have not installed the latest FOX Extenders Control Program (version 1.5
or newer), click , install the program, and reboot the PC. Reconnect the
Cancel
computer to the Configuration port on the DA.
radio button and click
No, not this time
nstall the software automatically
to exit the wizard.
"Starting the program" on the next page or return to the
Control" section.
You may need to repeat these steps if you subsequently connect the DA to
a different USB port on the same computer.
figure 8). See "Activating a USB port for the
2
.
Next
radio button and click
FOX DA8 Plus • Remote Control
2
.
Next
"Simple
13