Speaker Volume
The speaker volume potentiometer is labeled SPEAKER VOL on the control board. The speaker volume should be adjusted for
adequate sound. Adjusting the speaker volume too loud could cause feedback from the microphone.
1. Open the front of the telephone entry system and locate the speaker volume adjustment.
2. Push the "Push To Call" button to place a call to the resident. While they are talking, adjust the speaker volume
potentiometer for adequate sound. To increase the volume rotate the potentiometer clockwise, to decrease the
volume rotate the potentiometer counter clockwise.
Microphone Gain
The microphone gain potentiometer is labeled MIC VOL on the control board. This adjustment increases or decreases the
loudness in the telephone handset in the house.
1. Open the front of the telephone entry system and locate the Mic Vol adjustment.
2. Push the "Push To Call" button to place a call to the resident. After they answer, adjust the microphone gain
and ask the resident to let you know when the loudness in their telephone handset is set to a comfortable level.
Interface Board LED Status
Phone Line In Use - Yellow LED indicates that the phone line is being used (dial-out, call forwarding, etc.).
J1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
OV
System Keypad
Used to key in existing Access Codes and
Directory Codes during normal operation.
Also used to program the system features.
1812-161-L-12-11
SECTION 3 - ADJUSTMENTS
Interface
Board
1 1 1 1
1
2 2 2 2
2
3 3 3 3 3 3
3
4
5
6
7 7
8
9
0
PHONE LINE
IN USE
1972-011
J3
KEYPAD
1970-010
J2
1 2 3 4 5 6 7 8 910
Push To Call Button
Places a call from the 1812 to the
resident's house.
MASTER
CODE
Phone Line
in Use LED
Microphone
MIC VOL
Gain Adjust
Speaker
Volume
SPEAKER
VOL
Adjust
11
33