F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
Speed Control Rod, Lowering Speed Adjusting Rod and
Hydraulic Pipes
1. Remove the speed control rod (1).
2. Remove the plate (5).
3. Remove the external snap ring (8) and straight pin (11), and pull
out the lowering speed adjusting rod (2).
4. Remove the external snap ring (6) and straight pin (10), and pull
out the joint (7).
5. Remove the bracket (9).
6. Remove the return pipe 2 (4) and delivery pipe (3).
(When reassembling)
• Apply grease to the O-ring on the return pipe 2 (4)
IMPORTANT
• Be sure to tighten the delivery pipe mounting nuts to
specified torque.
• Apply liquid lock (Three Band 1324 or its equivalent) to the
plate mounting screws.
Tightening torque
Delivery pipe mounting nut
(1) Speed Control Rod
(2) Lowering Speed Adjusting Rod
(3) Delivery Pipe
(4) Return Pipe 2
(5) Plate
(6) External Snap Ring
Fuel Filter and Fuel Pump
1. Disconnect 2P connector (2) from the PTO switch.
2. Disconnect 2P connector (4) from the fuel pump (1).
3. Remove the fuel filter (3) and fuel pump (1).
4. Remove the negative cable (5).
(1) Fuel Pump
(2) 2P Connect (for PTO Switch)
(3) Fuel Filter
2-S14
TRANSMISSION
39.3 to 49.0 N·m
4.0 to 5.0 kgf·m
28.9 to 36.1 ft-lbs
(7) Joint
(8) External Snap Ring
(9) Bracket
(10) Straight Pin
(11) Straight Pin
W1042155
(4) 2P Connector (for Fuel Pump)
(5) Negative Cable
W1042801
KiSC issued 04, 2006 A