Kubota WSM F2880 Workshop Manual page 41

F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
Checking Hydraulic Hose
1. Check to see that all hydraulic hoses (1), (2) and hose clamps are
tight and not damaged.
2. If hoses and clamps are worn or damaged, replace or repair at
once.
(1) Power Steering Hose
Checking Fuel Line
CAUTION
• Stop the engine before attempting to carry out the work as
discribed below.
• Remember to check the fuel line periodically. The fuel line
is subject to wear and again, fuel may leak out onto the
running engine, causing a fire.
1. Check to see that all lines and hose clamps are tight and not
damaged.
2. If hoses and clamps are worn or damaged, replace or repair them
at once.
3. The fuel line is made of rubber and deteriorates regardless of
period of service. Replace the fuel hose together with the clamp
every two years and tighten securely.
4. However if the fuel hose and clamp are found damaged or
deteriorated earlier than two years, repair before running
machine.
5. After the fuel line and clamp have been changed, bleed the fuel
system.
IMPORTANT
• When the fuel line is disconnected for change, close both
ends of the fuel line with a piece of clean cloth or paper to
prevent dust and dirt from entering. Entrance of dust and
dirt causes malfunction of the fuel injection pump.
addition, particular care must be taken not to admit dust and
dirt into the fuel pump.
(1) Fuel Hose
G-28
G GENERAL
(2) Delivery Hose
(2) Hose Clamp
KiSC issued 04, 2006 A
In