F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
Separation of Bevel Gear Case and Rear Axle Gear Case
1. Remove the internal snap ring (7) and shims (6), and remove the
bevel gear (5) with the bearing.
2. Shift the external snap ring (8).
3. Remove the bevel support cover (1).
4. Tap out the bevel gear shaft (9) upward, and separate the bevel
gear case (4) from the rear axle gear case (3).
(When reassembling)
• Apply grease to the lip of oil seals (10).
• Apply liquid gasket (Three Bond 1208D or its equivalent) to both
side of a new gasket.
• Install the bevel gear (5) with the bearing, noting the number of
shims.
Bevel support cover
Tightening torque
mounting screw
(1) Bevel Support Cover
(2) Bevel Gear
(3) Rear Axle Gear Case
(4) Bevel Gear Case
(5) Bevel Gear
5-S9
REAR AXLE
18.7 to 32.3 N·m
1.9 to 3.3 kgf·m
13.8 to 23.8 ft-lbs
(6) Shim
(7) Internal Snap Ring
(8) External Snap Ring
(9) Bevel Gear Shaft
(10) Oil Seal
W1019233
KiSC issued 04, 2006 A