Kubota WSM F2880 Workshop Manual page 31

F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
Replacing Transmission Oil Filter Cartridge
CAUTION
• Be sure to stop the engine and remove the key before
changing the oil filter cartridge.
• Allow transmission case to cool down sufficiently; oil can be
hot and may cause burns.
1. Remove the transmission oil filter cartridge (1) with the filter
wrench.
2. Apply a slight coat of oil onto the cartridge gasket.
3. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of the rubber gasket.
4. After the new cartridge is replaced, the transmission fluid level
normally decreases a little. Add fluid if necessary.
5. Check for oil leaks around the filter gasket.
IMPORTANT
• To prevent serious damage to the hydraulic system,
replacement oil filter cartridge must be highly efficient. Use
only a genuine KUBOTA filter.
(1) Transmission Oil Filter Cartridge
G-18
G GENERAL
W1031068
KiSC issued 04, 2006 A