F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
Input Shaft
1. Remove the internal snap ring (4) and remove the oil seal (3).
2. Remove the external snap ring (2).
3. Tap out the input shaft (1) to the cylinder block side.
(1) Input Shaft
(2) External Snap Ring
Cover "A", "B" and Trunnion Shaft
1. Remove the internal snap rings (1) (5) both side.
2. Tap the trunnion shaft (3) using a soft hammer to create a
clearance between the case and the cover "B" (4).
Then, pry the cover "B" (4) open with a screw-driver. Pry the
cover "A" (2) in the same way.
3. Take out the trunnion shaft (3).
(When reassembling)
NOTE
• Take care not to damage the O-rings.
(1) Internal Snap Ring
(2) Cover "A"
(3) Trunnion Shaft
Charge Relief Valve
1. Remove the internal snap ring (1) and remove the plug (2).
2. Remove the spring (3) and push out the charge relief poppet (4).
(When reassembling)
NOTE
• Take care not to damage the O-ring.
(1) Internal Snap Ring
(2) Plug
2-S23
TRANSMISSION
(3) Oil Seal
(4) Internal Snap Ring
W1034986
(3) Cover "B"
(5) Internal Snap Ring
W1035205
(3) Spring
(4) Charge Relief Poppet
W1035400
KiSC issued 04, 2006 A