Kubota WSM F2880 Workshop Manual page 157

F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
Fender Support and Connecting Plate
1. Remove the fender supports (1), (3).
2. Remove the connecting plate (2).
(1) Fender Support (LH)
(2) Connecting Plate
Lever and Rod
1. Remove the 4WD lever rod (2) and 4WD lever (1).
2. Remove the PTO control rod (3) and PTO lever (4).
(1) 4WD Lever
(2) 4WD Lever Rod
Neutral Arm, Speed Change Arm and Side Frame
1. Remove the neutral spring (3).
2. Unscrew the holder shaft mounting screw (6) and remove the
neutral arm (5).
3. Remove the speed change arm (4).
4. Remove the brake return spring (8) and lift spring rod (7).
5. Remove the side frames (1), (2).
(When reassembling)
NOTE
• Apply liquid lock (Three Bond 1324 or its equivalent) to the
side frame mounting screws and speed change arm
mounting screw.
• Adjust the length "A" of adjusting screw (10) with adjusting
nuts (9).
• Adjust the length "B" of lift spring rod (7) with adjusting nuts
(11).
Side frame mounting
Tightening torque
screw and nut
(Reference)
• Length "A" : 15 to 20 mm (0.59 to 0.78 in.)
• Length "B" (LH) : 70 mm (2.8 in.)
• Length "B" (RH) : 50 mm (2.0 in.)
(1) Side Frame (LH)
(2) Side Frame (RH)
(3) Neutral Spring
(4) Speed Change Arm
(5) Neutral Arm
(6) Holder Shaft Mounting Screw
2-S16
TRANSMISSION
(3) Fender Support (RH)
W1043605
(3) PTO Control Rod
(4) PTO Lever
W1043870
62.8 to 72.5 N·m
6.4 to 7.4 kgf·m
46.3 to 53.5 ft-lbs
(7) Lift Spring Rod
(8) Brake Return Spring
(9) Adjusting Nut
(10) Adjusting Screw
(11) Adjusting Nut
W1043994
KiSC issued 04, 2006 A