Kubota WSM F2880 Workshop Manual page 306

F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
Adjusting Height and Assist Spring (Continued)
NOTE
• Before adjusting the cutting height, check the tire-pressure
of the front gauge wheels.
1. The cutting height can be adjusted from 25 mm to 129 mm (from
1.0 in. to 5.0 in.).
2. To adjust the cutting height, set the front gauge wheels (1), front
roller (5), anti-scalp rollers (4) and lift rods (2) as shown in the
table below. The recommended cutting height is approx. 51 to 77
mm (2.0 to 3.0 in.).
3. Check the length "L" of the lift spring rod (6). (without the grass
catcher)
(Reference)
• Length "L" (LH) : 70 mm (2.8 in.)
• Length "L" (RH) : 50 mm (2.0 in.)
Front Gauge
Cutting Height
Wheel
25 mm (1.0 in.)
32 mm (1.25 in.) D - XII
38 mm (1.50 in.)
45 mm (1.75 in.) D - YII
51 mm (2.0 in.)
58 mm (2.25 in.) C - XII
64 mm (2.50 in.)
71 mm (2.75 in.) C - YII
77 mm (3.0 in.)
84 mm (3.25 in.) B - XII
90 mm (3.5 in.)
97 mm (3.75 in.) B - YII
103 mm (4.0 in.)
110 mm
A - XII
(4.25 in.)
116 mm
(4.50 in.)
123 mm
A - YII
(4.75 in.)
129 mm (5.0 in.)
9-S14
Lift Rod Front Roller
E - X
E - XII
a
E - Y
E - YII
D - X
D - XII
D - Y
D - YII
C - X
C - XII
C - Y
C - YII
b
B - X
B - XII
B - Y
Y - XII
A - X
MOWER
Anti-Scalp
Roller
I
II
W1019983
KiSC issued 04, 2006 A