Kubota WSM F2880 Workshop Manual page 196

F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
Brake Assembly
1. Remove the internal snap ring (4).
2. Remove the differential gear shaft (2) with brake discs (5).
3. Remove the actuator (6) and steel balls (7).
(When reassembling)
• When installing the internal snap ring (4) to front axle case (3) as
shown in the figure.
• When installing the bearing holder (2) to the front axle case (3),
do not forget to install the straight pin (8).
(Refer to the figure)
(1) Bearing Holder
(2) Differential Gear Shaft
(3) Front Axle Case
(4) Internal Snap Ring
Brake Discs and Friction Plates
1. Remove the external snap ring (1).
2. Remove the brake discs and friction plates (2).
3. Remove the bearing holder (3).
(When reassembling)
• Install the brake discs with their holes (5) offset at least 1/3 of the
total hole area.
(1) External Snap Ring
(2) Brake Discs and Friction Plate
(3) Bearing Holder
4-S8
BRAKES
(5) Brake Disc
(6) Actuator
(7) Steel Ball
(8) Straight Pin
W1012864
(4) Differential Gear Shaft
(5) Hole
W1015294
KiSC issued 04, 2006 A