Kubota WSM F2880 Workshop Manual page 40

F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
Changing Rear Axle Differential Case Oil
1. Place the machine on level ground.
2. Place an oil pan underneath the rear axle differential case.
3. Remove the drain plug (2) and oil filler plug (1), and drain the
used oil completely.
4. After draining the oil, reinstall the drain plug and tighten.
5. Fill with new oil up to the upper level on the oil filler plug.
IMPORTANT
• Use the specified oil.
Refer to "LUBIRICANTS, FUEL AND COOLANT".
(See page G-7.)
(1) Oil Filler Plug
(2) Drain Plug
Changing Rear Axle Gear Case Oil
1. Place the machine on level ground.
2. Place an oil pan underneath the rear axle gear cases.
3. Remove the drain plug (3) and oil filler plug (1), and drain the
used oil completely.
4. After draining the oil, reinstall the drain plug and tighten.
5. Fill with new oil up to the level of the oil filler plug.
IMPORTANT
• Use the specified oil.
Refer to "LUBIRICANTS, FUEL AND COOLANT".
(See page G-7.)
(1) Oil Filler Plug
(2) Hexagon Wrench
Checking Radiator Hose and Hose Clamp
NOTE
• Check to see if the radiator hoses are properly connected
every 200 hours of operation or six months, whichever
comes first.
1. If the hose clamps (2) are loose or water leaks, tighten the hose
clamps (2) securely.
2. Replace the radiator hoses (1) and tighten the hose clamps (2)
securely, if the radiator hoses (1) are swollen, hardened or
cracked.
Precaution at Overheating
Take the following actions in the event coolant temperature near
or more than the boiling point, what is called "Overheating".
1. Stop the machine operation in a safe place and keep the engine
unloaded idling.
2. Don't stop the engine suddenly, but stop it after about 5 minutes
of unloaded idling.
3. Keep yourself well away from the machine for further 10 minutes
or while the steam blows out.
4. After engine cools, check for cause of overheat and repair before
starting engine.
(1) Radiator Hose
G-27
G GENERAL
(A) Oil level is acceptable within this
range.
W1047321
(3) Drain Plug
W1047609
(2) Hose Clamp
KiSC issued 04, 2006 A