pigtronix Infinity looper User Manual page 4

-- QUICK START GUIDE –
Turn on the Infinity, it will load Preset 0 (the blank
canvas) upon power up.
Set the MASTER VOLUME to 3:00 and both LOOP
VOLUME knobs to 12:00
Press Loop 1 footswitch to record (You must
record on Loop 1 first)
Press Loop 1 footswitch again to close the loop
and begin playback
Press Loop 1 footswitch again to open an
overdub on Loop 1.
Press Loop 1 footswitch again to close the
overdub on Loop 1.
Listen to your loop, then press the STOP footswitch
to halt playback.
Press Loop 1 footswitch again to resume
playback.
Press Loop 2 to ARM Loop 2... the ARM light
above Loop 2 will blink, indicating that Loop 2 will
automatically begin recording at the top of the
next pass through the loop cycle.
Loop 2 begins recording in sync with the
beginning of Loop 1 and will automatically close
at the end of Loop 1.