pigtronix Infinity looper User Manual page 26

SYNC Multi:
Pressing the SYNC MULTI switch will cycle between
the various sync options.
With none of the sync lights turned on, Loop 1
and Loop 2 run independently.
In "non-sync" mode, the length and start / stop
points of Loop 1 and Loop 2 have no impact on
one another. If Loop 2 is recorded in "non-sync"
mode, the "sync" modes become unavailable.
x1 – When the x1 light is lit, the length of Loop 2
will be locked to the Length of Loop 1. In this
setting, the length and start/stop points of both
loops will be locked to each other.
x2 – When the x2 light is lit, the length of Loop 2
will be locked to 2 times the Length of Loop 1.
x3 – When the x3 light is lit, the length of Loop 2
will be locked to 3 times the Length of Loop 1.
x4 – When the x4 light is lit, the length of Loop 2
will be locked to 4 times the Length of Loop 1.
x6 – When the x6 light is lit, the length of Loop 2
will be locked to 6 times the Length of Loop 1.
When any of the MULTI SYNC settings are
selected, recording on Loop 2 will automatically
begin at the top of the next loop cycle after
recording is initiated and will close at the
appropriate length multiple, beginning playback
in sync with Loop 1 once closed.