pigtronix Infinity looper User Manual page 23

Holding the STOP MODE switch down will select
between these options
FULL – STOP footswitch will halt loop audio
immediately when pressed
TRAILS – Pressing the STOP footswitch anytime
within the loop cycle will halt loop audio when
the end of the armed Loop is reached.
FADE – Pressing the STOP footswitch anytime
within the loop cycle Fades loop audio from the
time when the STOP footswitch is pressed until the
end of the armed Loop is reached.
In the case where ALL stop is selected (and
material is recorded on both loops), the TRAILS
and FADE functions apply to both loops based
upon the timing of Loop 2.
Erase:
To erase a loop, press and hold down the STOP
footswitch.
When the erase command is triggered, the STOP
LED the current ARM LED and the Multi-Segment
Digit will flash once to indicate audio has just
been erased.
The Erase function is tied to the STOP MODE
selection (ARM or ALL). When ARM is chosen,
holding down the STOP switch will erase the