pigtronix Infinity looper User Manual page 12

have been made but not saved, the decimal
point will flash. If you want to keep your changes,
simply follow the save process explained above
without changing the selected bank.
To Copy a preset from one bank to another
simply initiate the save process as explained
above on a bank that already contains audio. In
order to copy a loop from one slot to another,
you must make at least one change to the loop.
This can be an audio or mode change.
The decimal point will illuminate to indicate that
audio is present in a Loop bank. When changes
have been made but not saved, the decimal
point will flash. If you want to keep your changes,
simply follow the save process explained above
without changing the selected bank.
In certain instances while saving, the Infinity
Looper may need to copy data from one sector
of the disk to another. When this happens, the
numeric display will show a flashing "C" while the
copy is in process.
The Stop footswitch also functions as an ESC key
when you are in the process of saving or loading
a loop and want to cancel that action.
The Minimum length of a Loop is 2.5 seconds