pigtronix Infinity looper User Manual page 17

When a delayed command has been
initiated, the relevant footswitch LED will blink
to indicate a pending action and will turn solid
in color once the action is taken.
CLIP LED – This red LED between the Loop
Volume knobs will indicate when the input
signal is reaching the maximum headroom of
the Infinity's recording engine and begins to
trigger the analog limiter stages. If the CLIP
LED is lighting up solid red, reduce the output
level of your instrument until the CLIP LED is just
beginning to light up at the peaks in your
audio signal.
MULTI-SEGMENT DIGIT – This numeric display
tells the user which preset bank is currently
selected and is also used to confirm firmware
update "F" to indicate copy in progress "C"
and USB active "U" states.
The decimal point located to the right of the
digit lights up to indicate that audio has been
recorded to a preset bank. When changes
have been made to a preset but not saved,
the decimal point will blink. Once the changes
have been saved, the decimal point will
return to solid.
When all audio is erased from a preset, the
digit will blink to indicate a change. Once you
save the preset in this state, the decimal point