pigtronix Infinity looper User Manual page 29

that you should save this audio somewhere else
by turning the encoder to select a different preset
slot.
The decimal point will illuminate to indicate that
audio is present in a Loop bank. When changes
have been made but not saved, the decimal
point will flash. If you want to keep your changes,
simply follow the save process explained above
without changing the selected bank.
To Copy a preset from one bank to another
simply initiate the save process as explained
above on a bank that already contains audio.
In certain instances while saving, the Infinity
Looper may need to quickly copy data from one
sector of the disk to another. When this happens,
the digit will show a flashing "C" while the copy is
in process.
MIDI:
When a MIDI clock source is present, the Infinity
Looper will synchronize its actions to the MIDI beat
clock, acting as a SLAVE device.
The MIDI actions of the Infinity Looper are
quantized to the measure (assuming 4/4 time)
when MIDI is running. Any action that is meant to
obey MIDI clock will occur at the beginning of the
next measure after the command is initiated.