pigtronix Infinity looper User Manual page 31

MIDI Commands that trigger Infinity Looper
Actions:
In order to enable the Infinity Looper to obey MIDI
commands other than MIDI Beat clock, you must
hold down the SYNC switch when powering up.
MIDI Stop - MIDI Stop command stops all Loop
Audio. This is the equivalent of hitting the STOP
footswitch on the Infinity Looper
MIDI Start - MIDI Start command begins loop
playback. In ALL mode, both loops start. In ARM
mode, only the armed loop starts.
MIDI Song Select – The MIDI Song Select
command will cause the Looper to change
preset banks so that you can move between
different sets of loops during performance. Allow
up to 4 seconds for Song Select Changes to take
effect.
Infinity Looper Application
The Infinity Looper Application comes pre-
installed on your Infinity Looper pedal. To run the
application, plug in your Looper via USB and
open the appropriate folder (PC or MAC) from
the on-board drive and then click on the
LooperApp.exe file. If using Windows 7, please
right-click and choose "run as administrator"