pigtronix Infinity looper User Manual page 33

Choose the firmware update option from the
TOOLS menu within the Infinity Looper
Application. Choose the "automatic" option.
Close the Infinity Looper Application.
Power down the Infinity Looper (eject first on
MAC) and then disconnect the USB cable from
the Infinity Looper.
WHILE HOLDING DOWN the INPUT SPLIT switch,
reconnect the power supply. The digit will display
an "F" to indicate the firmware update process
has been initiated. When finished, the Infinity will
re-boot automatically and your firmware will be
updated.
If you followed the above instructions correctly
and the "F" does not appear, then the firmware
you are trying to install is the same as what is
currently running on your device.
Manual Firmware update:
To update your Infinity Looper with the latest
firmware, power up the Infinity Looper and plug it
into a PC with the supplied USB-A to microUSB
cable. The Infinity is not a bus powered device
and must be plugged into the wall using the
supplied adapter in order to connect via USB.
Once the Infinity has been connected to a