Configuration Problems - HP KAYAK XU800 Troubleshooting Manual

Configuration Problems

If your PC Workstation boots normally, but you are having problems
configuring different parts of your PC Workstation.
Symptom
PC Workstation starts to boot, but a POST (Power-
On Self-Test) error message is displayed on the
screen.
You cannot turn off the PC Workstation.
You have forgotten your password.
There is an IRQ conflict when you install a new accessory board.
Your PC Workstation has an audio problem.
Your PC Workstation has a software problem.
Your PC Workstation repeatedly loses its configuration settings.
You have problems using the Euro Symbol
Type of Problem
•
CMOS test error.
•
Keyboard or mouse are not working correctly.
•
Floppy disk drive LED does not appear.
•
Hard disk drive, DVD, CD-RW or CD-ROM drive are
not accessible.
•
Serial or Parallel ports are incorrectly configured.
•
Devices are not cabled correctly.
•
Device drivers missing or incorrectly installed.
•
No sound when running any application.
•
No sound when playing a CD-ROM.
•
No output from the digitized sounds.
•
Audio input from the microphone too low, or none
at all.
•
PC Workstation hangs while recording.
•
Software application will not run.
•
Date and time are wrong.
Refer to page 25.
Refer to page 26.
Refer to page 27.
Refer to page 28.
Refer to page 29.
Refer to page 30.
Refer to page 30.
Refer to page 31.
Refer to page 32.
Refer to page 33.
Refer to page 34.
Refer to page 35.