HP KAYAK XU800 Troubleshooting Manual page 37

Clearing the CMOS
1 Turn off the PC Workstation, disconnect the power cord and data
cables, then remove the cover.
2 Set the system board switch
CMOS memory.
3 Replace the cover, and only reconnect the power cord.
4 Reboot the PC Workstation. A message similar to the following will
be displayed:
"Configuration has been cleared.
Switch off the PC Workstation and remove the cover.
Reset the "Clear Configuration" switch to OFF (Up).
Switch on the PC Workstation and allow it to startup.
To modify the default configuration information:
press [F2] when prompted during self-test (POST), to
5 Turn off the PC Workstation, disconnect the power cord, and remove
the cover.
6 Set the system board switch
configuration.
7 Replace the cover, and reconnect the power cord and data cables.
8 Switch on the PC Workstation. Run the Setup program by pressing
. Then press
downloaded and saved.
9 Press to save the configuration and exit from the Setup
program.
4 to the DOWN
You can now:
Replace the cover.
enter Setup."
4 to the UP
, the CMOS default values will be automatically
Configuration Problems
Troubleshooting BIOS Problems
position to clear the
position to retain the
37