Refer To - HP KAYAK XU800 Troubleshooting Manual

Error Message...
ERROR !
CD-ROM
ERROR !
Floppy Drive B
ERROR !
Serial Number
ERROR !
Product Name
20
Your PC Workstation Does Not Start Correctly
Case 4 — Boot Process Fails
Action to Take...
•
Check that the CD-ROM drive has
been detected in the Setup
program. Press to enter the
F2
Setup program
•
Check that the data and power
cables are correctly connected to
the CD-ROM drive.
•
Also refer to page 28 for further
troubleshooting help.
•
Check that the data and power
cables are correctly connected to
Floppy disk drive B.
•
Also refer to page 27 for further
troubleshooting help.
•
After a system board replacement,
the serial number (located on the
back of the PC Workstation) is
required. Follow the instructions on
the monitor to enter the system
serial number.
After a system board replacement,
the product name (XU800) is required.
Follow the instructions on the monitor
to enter the product name.
Error Message.... Action to Take...
•
ERROR !
Floppy Drive B
•
•
ERROR !
No Proc. Termin.
•
ERROR !
IDE Device "n"
•
ERROR !
Motherboard
If there is still a problem, replace the
system board.
Check that the data and power
cables are correctly connected to
Floppy disk drive A.
Also refer to page 27 for further
troubleshooting help.
Check that the termination card is
present and correctly installed in
processor slot 2 in a single
processor system.
Check that the IDE slave and
master devices per channel have
been correctly defined in the Setup
program. Press to enter the
F2
Setup program, then IDE.
Check that the System board is
correctly configured (power,
processor, terminator, PCI cards,
cables and switches).