HP KAYAK XU800 Troubleshooting Manual page 14

Symptom...
ERROR !
No RIMM
ERROR !
No DIMM
In some cases, the LCD panel
could display a smiling face, but
the system does not boot.
HP Kayak XU800
Info Services
For information about the different memory configurations, refer to page 15.
Symptom...
ERROR !
No Video
Symptom...
•
Cables are incorrectly fitted to
the corresponding system
board connectors.
•
System board switches
incorrectly set.
Your PC Workstation Does Not Start Correctly
Case 3 — Detected Hardware Error
Check that...
•
RDRAM modules are correctly
installed in the RIMM sockets.
•
RDRAM modules are installed.
•
SDRAM modules are correctly
installed.
•
SDRAM modules are installed.
•
RDRAM modules are correctly
installed in the RIMM sockets.
•
Continuity modules are correctly
installed.
Check that...
Video card is:
•
Present.
•
Seated correctly in the AGP PRO connector.
•
Cabled correctly.
•
Not defective.
Check that...
Cables are correctly connected.
If required, refer to the service label inside the cover for the system board layout.
Refer to the service label inside the cover for correct settings.
Or, refer to "System Board Switches" on page 39.
Refer to page 21 for information about runtime error codes.
14
Symptom... Check that...
•
ERROR !
RIMM Speed
•
ERROR !
Mem MisCompare
Case 3 — Detected Hardware Error is continued on the next page
RDRAM have same speed
ratings.The part number on the
paired RDRAM modules should be
the same. If different, use the
RDRAM module delivered with
your PC Workstation. Remove the
other module.
RDRAM modules are installed in
pairs with the same capacity,
speed or part number.
First pair of RDRAM modules are
installed in sockets A0-B0.
Second pair of RDRAM modules
are installed in sockets A1-B1.