Other Configuration Problems - HP Brio ba300 Troubleshooting Manual

If You Have a Problem
Serial or Parallel Port Test Error
Have you checked that...
The port is correctly configured in the PC's
Setup program
You have not connected a device incorrectly or
forgotten to switch it on
You have installed the correct device drivers
There is not a hardware problem
You are using the latest BIOS for your PC
I I I I f f f f t t t t h h h h e e e e p p p p r r r r ob ob ob obl l l l e e e e m m m m p p p p e e e e r r r r s s s s i i i i s s s s t t t t s s s s , , , , c c c c o o o o n n n n t t t t a a a a c c c c t t t t y y y y o o o o u u u u r r r r a a a a u u u u t t t t h h h h o o o o r r r r i i i i z z z z e e e e d d d d s s s s u u u u pp pp pp ppo o o o rt rt rt rt p p p p r r r r o o o o v v v v i i i i d d d d e e e e r r r r

Other Configuration Problems

If the POST produces an error not covered in this section...
Have you checked that...
The Setup program settings are correct
You are using the latest BIOS for your PC
I I I I f f f f t t t t h h h h e e e e p p p p r r r r ob ob ob obl l l l e e e e m m m m p p p p e e e e r r r r s s s s i i i i s s s s t t t t s s s s , , , , c c c c o o o o n n n n t t t t a a a a c c c c t t t t y y y y o o o o u u u u r r r r a a a a u u u u t t t t h h h h o o o o r r r r i i i i z z z z e e e e d d d d s s s s u u u u pp pp pp ppo o o o rt rt rt rt p p p p r r r r o o o o v v v v i i i i d d d d e e e e r r r r
22
How
Ö
1 Switch the PC OFF then ON.
2 When the message Press F2 to Enter Setup appears, press the F2
key.
3 Check the port is enabled and the correct setting is selected under I/O
Device Configuration in the Advanced menu.
Ö
1 Switch off the PC.
2 Plug the cables into the correct connectors on the back of the PC.
3 Switch on the PC and the external devices.
Ö
Refer to the documentation for your serial or parallel device.
Ö
Run e-Diagtools. Refer to page 24.
Ö
Download the latest BIOS and instructions for its installation from HP's Web
at:
www.hp.com/go/briosupport
How
Ö
1 Turn on or restart the PC.
2 When the message Press F2 to Enter Setup appears, press the F2
key.
Ö
Download the latest BIOS and instructions for its installation from HP's Web
at:
www.hp.com/go/briosupport