HP KAYAK XU800 Troubleshooting Manual page 19

POST Test Sequence
and POST Error
Error Message...
ERROR !
Keyboard
ERROR !
Date & Time Lost
Following the pre-boot checks, the POST (Power-On Self Test)
sequence is initiated. It should be noted that in some cases, a Beep and
Post Error can occur at the same time.
The following table shows the type of error message that could be
displayed on the MaxiLife status panel, and the action to take.
Action to Take...
•
Check that the keyboard is
connected to its socket located on
the rear of the PC Workstation.
•
Also refer to page 26 for further
troubleshooting help.
If there is still a problem, replace the
keyboard.
1 Reboot PC Workstation, Press
to enter the Setup program,
F2
then to load the default BIOS
F9
settings.
2 Clear the CMOS. Refer to page 37
for instructions.
3 If there is still a problem, replace
the battery located on the system
board. Details about the battery
and installation procedure are
described on page 34.
Your PC Workstation Does Not Start Correctly
Error Message.... Action to Take...
Perform the following actions in this
order:
ERROR !
1 Press
Invalid Setup
2 Clear the CMOS. Refer to page 37
3 Flash the latest version of the BIOS
4 Check that the processor is firmly
•
ERROR !
Floppy Ctrl
•
•
If there is still a problem, replace the
system board.
Case 4 — Boot Process Fails is continued on the next page
Case 4 — Boot Process Fails
to enter the Setup
F2
program, then to load the
F9
default BIOS settings.
for instructions.
by using the system recovery
procedure. Set switch 1 to the
DOWN position. Refer to page 36
for instructions.
inserted in the processor socket.
Check that the floppy disk
controller has been enabled in the
Advanced menu. Press to
F2
enter the Setup program.
Check that the floppy disk drive(s)
data and power cables are
correctly connected.
Also refer to page 27 for further
troubleshooting help.
19