Detection Area Of The Reflective Sensor - Toshiba B-EX4T2 SERIES Owner's Manual

7. SUPPLY SPECIFICATIONS
Min. 2.0 mm
(Min.6.0mm
when the cutter
is used.)
Magnified view of detection area

7.1.3 Detection Area of the Reflective Sensor

The Reflective Sensor is movable from the centre to the left edge of media.
The reflection factor of the Black Mark must be 10% or lower with a waveform length of 950 nm.
The Reflective Sensor should be aligned with the centre of the Black Mark.
The black marks, if necessary, must be printed on the labels in the gap areas.
Rectangular holes can substitute the black marks, on the condition that nothing is printed on the back
side.
Min. 2.0 mm
Transmissive
Sensor position
Necessary
detection area
Label
Gap
Label
Min. 12 mm
Reflective Sensor
position
Transmissive
Sensor
16mm
Reflective
Sensor
6mm
E7-4
ENGLISH VERSION EO1-33094
(Center of paper)
View from the
print side
Paper feed
direction
(Center of paper)
Perspective on the back side
View from the
print surface
Paper feed
direction
7.1 Media