Dump Mode Setting - Toshiba B-EX4T2 SERIES Owner's Manual

2. PRINTER SETUP

2.6.7 Dump Mode Setting

USER SYSTEM MODE
<5>BASIC
<6>Z-MODE
<7>AUTO CALIB
<8>DUMP MODE
NOTES:
1. If a file with the same name
already exists in the USB
memory, it will be
overwritten.
2. Selecting "RS-232C" or
"CENTRONICS" without
the optional board installed
causes a 0-KB file to be
output.
3. If an error occurs while
using the USB memory, the
error message is displayed.
For details, refer to Section
2.6.12 Copying Data
to/from USB Memory.
In Dump Mode, the data in the receive buffer is printed. The data
is expressed in hexadecimal values.
verification of the programming commands or the debug of the
program.
(1) BUFFER
Select the receive buffer to dump.
• RS-232C
• CENTRONICS
• LAN
• BASIC1
• BASIC2
• USB
• RFID
(2) DUMP LIST
This parameter is to choose the output destination.
• USB MEMORY
• PRINT
When USB MEMORY is selected:
A file is automatically created in the USB memory and named in
the following format based on the printer model and saved date.
/ATA0/DUMP/B-EX4T1_DUMP_1007291030.BIN
(e.g. B-EX4T Type1, 10:30, July 29, 2010)
When PRINT is selected:
Choose a printing method.
• ON DEMAND
• ALL
E2-27
ENGLISH VERSION EO1-33094
This operation allows
RS-232C receive buffer
Centronics receive buffer
Network I/F receive buffer
BASIC Interpreter:
I/F → Interpreter buffer
BASIC Interpreter:
Interpreter buffer → I/F
USB receive buffer
RFID receive buffer
Saves in the USB memory. →
Prints out →
Prints 166 lines of data (approx. 50 cm), then
stops. Subsequent data is printed when the
[ENTER] key is pressed.
Prints all data in the receive buffer.
2.6 Printer Setting