Rfid Tags - Toshiba B-EX4T2 SERIES Owner's Manual

7. SUPPLY SPECIFICATIONS

7.1.5 RFID Tags

Available RFID tag types are different depending on the RFID modules/printers, as follows:
B-EX700-RFID-H1-QM-R
• TAGSYS C210
• TAGSYS C220
• TAGSYS C240
• TAGSYS C320 (Only when the TAGSYS S003 module is used.)
• I-Code
• Tag-it
• ISO15693
Cautions for using RFID Tags
(1) Lift-up of Print Head
An RFID tag chip or the print head may be damaged when the print head passes over the chip.
(2) Storage of RFID Supplies
Do not store RFID tags close to printers, as their read/write performance may be compromised when
they are used.
(3) Roll-type RFID Supplies
When RFID supplies are to be rolled, roll hardness must be considered.
Although it depends on the type of adhesive, tag, and backing paper, RFID-tag embedded labels tend
to stay rolled. Especially, when they are outside wound, a paper jam error may occur. Unless
otherwise specified, it is recommended that the RFID-tag embedded labels be inside wound.
(4) Sensor
When the transmissive sensor or reflective sensor is enabled, transmittance or reflectivity of a label or
tag may vary at an RFID-tag embedded area depending on the pattern of the antenna or other factors.
In such cases, a manual threshold setting is required. For details, refer to Section 2.10 Threshold
Setting.
(5) Cutter
When an RFID label or tag is used in cut issue mode, care must be taken not to cut the antenna of the
RFID tag or the IC chip so as not to damage the cutter.
(6) Static Electricity
When printing is performed in a place where humidity is low or under some specific conditions, writing
data on an RFID tag may fail due to static electricity generated by the label or ribbon.
E7-6
ENGLISH VERSION EO1-33094
7.1 Media