Toshiba B-EX4T2 SERIES Owner's Manual page 32

2. PRINTER SETUP
2.6.2 Parameter Setting
(Cont.)
NOTE:
Pre-strip function is automatically
enabled when the print speed is
set to 10 ips or faster. However,
the print speed is corrected
depending on the EX I/O
parameter setting, as follows.
EX I/O: TYPE 1
10 ips (203 dpi)
8 ips (305 dpi)
EX I/O: TYPE 2
Specified speed
(4) FW/BK ACT.
• MODE1
The printer waits for next issue after 13.7-mm
media has been fed forward.
• MODE2
When thermal transfer and cut mode are
selected, the printer feeds 6-mm media
backward, then waits for next issue after 3-mm
media has been fed forward. From this position,
the printer starts the on-the-fly printing for next
issue. The 3-mm distance to the home position
is fed at 3 ips.
(5) PRE PEEL OFF
Select whether to activate the pre-strip function.
parameter is set to ON, the top edge of a label is separated
(pre-stripped) from the backing paper before the label is printed.
This function is intended to make the strip issue easier in the
case of labels that are hard to strip due to the label density,
strength of the adhesive used, or the print speed.
• OFF
Disables pre peel off
• ON
Enables pre peel off
(6) BACK SPEED
Select back feed speed.
In strip issue a back feed speed of 3 ips may cause the correct
distance not to be fed due to a lack of torque, slippery media
surface, etc. In such cases reduce the back feed speed to 2 ips
to ensure the correct feed amount.
• STD
3ips
• LOW
2ips
(7) TYPE OF RIBBON
Select type of ribbon.
When a coating side of the ribbon is the outside, chooses CSO.
When a coating side of the ribbon is the inside, chooses CSI.
• CSO
Coated side out
• CSI
Coated side in
E2-18
ENGLISH VERSION EO1-33094
2.6 Printer Setting
When this