Canopy Screw (4)
Step 9. Carefully tuck the wires around the
Receiver and Hanging Bracket as not to loosen the
wire caps�
Step 10. Insert 2 Canopy Screws into the Hanging
Plate diagonally across from each other so they
match the keyholes on the canopy�
WARNING: Do not let Hanger
Bracket or Canopy crimp the
wires�
Step 11. Raise the Canopy over the Hanger Bracket�
Align the partially installed screws with the key slots
in the canopy�
Step 12. Twist the Canopy clockwise to secure�
Step 13. Install the third & fourth canopy screws in
the round holes on Canopy� Securely tighten all four
screws�
Step 14. Using both hands, push the Canopy Trim
ring up to the top of the Canopy�
Step 15. Twist the Canopy Trim ring clockwise to
secure it to the Canopy�
V
CANOPY HARDWARE
SECURING THE CANOPY
Round
Hole
icente
Screw Driver
Canopy Screws
Keyhole Slots
Keyhole Slot
15