Step 1. Remove the Paper Shield from the top of
the motor�
Step 2. Loosen Set Screw on Motor Adaptor�
Step 3. Feed the wires from the top of the fan
through the Motor Adaptor Cover, Trim Ring,
Canopy, and downrod�
Step 4.
Note: Make sure all the wires are on the same side
of the metal dowel pin inside the dowrod�
Step 5. Twist the Pipe Assembly into the Motor
Adapter by turning Counter-Clockwise�
CAUTION: The Motor Adapter has a special
coating on the threads� Do not remove this
coating; the coating prevents the downrod
from unscrewing� Once assembled, do not
remove the downrod�
CAUTION: Failure to fully lock in the downrod
before securely tightening the set screw may
cause the fan to separate from the downrod during
normal operation!
Step 6. Securely retighten the setscrew on the
Motor Adapter�
8' CEILING INSTALLATION
Downrod
Canopy
V
icente
Set Screw
Trim Ring
Motor Adaptor
Cover
Motor Adaptor
11