Table of Contents
Advertisement
Apply all the grease to the top of the processor in one of the following patterns to ensure even
6.
distribution:
CAUTION:
pairs (in an "X" pattern). Do not overtighten the screws as this can damage the board,
connectors, or screws. Use the wrench supplied with the system to reduce the possibility of
overtightening the screws.
Install the heatsink.
7.
Install the air baffle
8.
Install the access panel
9.
Dedicated iLO connector module
Power down the server (on page 27).
1.
Remove the server from the rack (on page 28).
2.
Heatsink retaining screws should be tightened or loosened in diagonally opposite
("Processor air
baffle" on page 32).
("Primary access
panel" on page 29).
Removal and replacement procedures 50
Advertisement
Table of Contents
