Enabling The Dedicated Ilo Management Module; Riser Boards - HP Apollo 2000 Maintenance And Service Manual

Remove the failed dedicated iLO management port card.
7.
To replace the component, reverse the removal procedure.

Enabling the dedicated iLO management module

To enable the dedicated iLO management module:
During the server startup sequence after installing the module, press F9 in the POST screen.
1.
The System Utilities screen appears.
Select System Configuration | iLO 4 Configuration Utility.
2.
The iLO 4 Configuration Utility screen appears.
Select Network Options, and then press Enter.
3.
The Network Options screen appears.
Set the Network Interface Adapter field to ON, and then press Enter.
4.
Press F10 to save your changes.
5.
A message prompt to confirm the iLO settings reset appears.
Press Enter to reboot the iLO settings.
6.
Press Esc until the main menu is displayed.
7.
Select Reboot the System to exit the utility and resume the boot process.
8.
The IP address of the enabled dedicated iLO connector appears on the POST screen on the subsequent
boot-up. Access the Network Options screen again to view this IP address for later reference.

Riser boards

To remove the component:
CAUTION:
remove all AC power cords before removing or installing the PCI riser board assembly.
Power down the node (on page 27).
1.
To prevent damage to the server or expansion boards, power down the server and
Removal and replacement procedures 64