Two-bay models
o
Four-bay models
o
Remove the SAS/SATA backplane
13.
To replace the component, reverse the removal procedure.
SAS/SATA backplane
To remove the component:
Power down the server (on page 27).
1.
Remove the server from the rack (on page 28).
2.
Remove the primary access panel
3.
Remove the secondary access panel (on page 28).
4.
Disconnect the hard drive cables from the system board.
5.
("SAS/SATA
backplane" on page 40).
("Primary access
panel" on page 29).
Removal and replacement procedures 40