Power supply
To remove the component:
Power down the server (on page 27).
1.
Remove the server from the rack (on page 28).
2.
Remove the primary access panel
3.
Disconnect the removable media and hard drive power cables from the hard drive backplane.
4.
Disconnect the auxiliary power supply cable and the main power supply cable from the system
5.
board.
Remove the power supply.
6.
To replace the component, reverse the removal procedure.
Heatsink
To remove the component:
WARNING:
internal system components to cool before touching them.
Power down the server (on page 27).
1.
Remove the server from the rack (on page 28).
2.
Remove the primary access panel
3.
Remove the air baffle
4.
CAUTION:
"X" pattern).
Loosen the four screws securing the heatsink:
5.
Loosen each screw three or four turns in the counterclockwise direction.
a.
("Primary access
To reduce the risk of personal injury from hot surfaces, allow the drives and the
("Primary access
("Processor air
baffle" on page 32).
Heatsink retaining screws should be loosened in diagonally opposite pairs (in an
panel" on page 29).
panel" on page 29).
Removal and replacement procedures 44