System Board - HP ProLiant DL320 Generation 5p Maintenance And Service Manual

Remove the primary access panel
3.
Remove the iLO connector module.
4.
To replace the component, reverse the removal procedure.

System board

To remove the component:
Power down the server (on page 27).
1.
Remove the server from the rack (on page 28).
2.
Remove the primary access panel
3.
Remove the secondary access panel (on page 28).
4.
Remove the PCI riser board assembly
5.
Remove all DIMMs ("DIMMs" on page 31).
6.
Remove the air baffle
7.
Remove the fan assembly
8.
Disconnect the power supply cables from the system board
9.
Disconnect the SATA hard drive cables from the system board ("Cabling" on page 75).
10.
Disconnect the hard drive cage cables and the front panel/LED cable from the system board
11.
("Cabling
Remove the dedicated iLO connector module, if installed
12.
page 50).
Remove the heatsink ("Heatsink" on page 44).
13.
("Primary access
("Primary access
("Processor air
("Fan assembly" on page 32).
overview" on page 75).
panel" on page 29).
panel" on page 29).
("PCI riser board assembly" on page 41).
baffle" on page 32).
("Server
("Dedicated iLO connector
cabling" on page 75).
module" on
Removal and replacement procedures 51