Speaker Check - Cary Audio Design Cinema 12 Owner's Manual

AUTO SOUND SETUP
interfere with the AUTO SETUP function by giving the microphone other
things to listen to besides the test tones it uses.
• WARNING: The set up noise is loud and should not be used at times
when it might disturb others. The test noise is similar to PINK NOISE
with equal energy in all audible octaves of sound.
3. Make sure the Cinema 12 is set to an input 2-8 where no source device is
connected before performing the auto-setup. DO NOT set the Cinema 12 to either
HDMI 1 - 4 as the auto-setup feature will not function if the unit is set to an
HDMI input.
4. Press the AUTO SETUP button on the remote handset.
VFD will display:
Auto Sound Setup?
Press OK to start.
5. Press the OK button on the remote to start measurement.
VFD will display:
Connect Microphone?
Press OK to start.

6. Speaker Check

During the Speaker Check, the following appears on the VFD display and checks
are made to detect the test sound in the listening room, whether there are speakers
connected to each channel or not and the polarity of the speakers as they are
connected. Please note; the sound output from the Cinema 12 during the
speaker check may be quite loud.
Speaker check
FL.................................... Yes
CEN................................. Yes
FR.................................... Yes
SR.................................... Yes
SBR ................................. Yes
SBL ................................. Yes
SL.................................... Yes
SW................................... Yes
Total: 8 speakers
(Yes/No)
(Yes/No)
(Yes/No)
(Yes/No)
(Yes/No)
(Yes/No)
(Yes/No)
(Yes/No)
35