Cary Audio Design Cinema 12 Owner's Manual page 47

MANUAL SOUND SETUP
In general, low frequencies will be redirected from the speakers with the highest
crossover points to the speakers with the lowest crossover points. Low-frequency signals
lower than the lowest crossover point will be redirected to the subwoofer.
NOTE: The following selected menus appear on the Cinema 12 Display:
MOVIE SPK Setting
Set Crossover Points
To set the crossover points for your speakers:
1. Press the SETUP button to enter the "SETUP MENU".
The "SETUP MENU / LISTENING PROFILES" menu appears on the front panel
display.
2. Press the OK button on the remote to enter the "LISTENING PROFILES" setup
menu.
The "LISTENING PROFILES / MEMORY 1" menu appears on the front panel
display.
3. Press the OK button on the remote to enter the MOVIE "Set Speaker Config"
settings menu.
The "MOVIE SPK Setting / Set Speaker Config" menu appears on the front panel
display.
4. Press the button on the remote until you reach "SET CROSSOVER POINTS"
on the front panel display.
The "MOVIE SPK / Set Crossover Points" menu appears on the front panel
display.
5. Use the and
The crossover settings appear as follows as you scroll through them:
From 40 to 150 Hz in 10 Hz steps or FULL range.
6. Press the button on the remote when you have made a selection.
Repeat step 5 for the Center, Front R, Side R, Surr BR, Surr BL, Side L and
Subwoofer speaker.
7. When you have finished setting the crossover points for all of the speakers within
your system, press the
return to the previous "SETUP MENU" to continue through the system setup
process, or simply press the SETUP button to exit the "SETUP MENU"
completely.
buttons on the remote to adjust the FL (Front Left) Crossover.
button on the remote to select BACK, then press OK to
45