Set Analog In Configuration - Cary Audio Design Cinema 12 Owner's Manual

SETUP MENU

SET ANALOG IN CONFIGURATION

The Cinema 12 allows analog sources to select bypass mode or DSP mode. When you
select the BYPASS mode, the Cinema 12 passes analog input signals directly to the main
audio output connectors with no EQing or Sub output.. When you select DSP mode, the
Cinema 12 sends analog input signals through A/D conversion and internal processing
before passing them to the main audio output connectors. This allows analog sources to
use bass management, speaker crossovers, speaker distance calibration, and Room EQ.
To set Analog IN Configuration:
1. Press the SETUP button on the remote to enter the "SETUP MENU".
The "SETUP MENU / LISTENING PROFILES" menu appears on the front panel
display.
2. Press the button on the remote until you reach "INPUTS" on the front panel
display.
The "SETUP MENU / INPUT" menu appears on the front panel display.
3. Press the OK button on the remote to enter the "INPUTS" setup menu.
The "INPUTS / Assigned Inputs" menu appears on the front panel display.
4. Press the button on the remote until you reach the "SET ANALOG IN
CONFIG" menu.
The "INPUTS / Set Analog In Config" menu appears on the front panel display.
5. Press the OK button on the remote to enter the "SET ANALOG IN CONFIG"
menu.
The "Set Analog In Config / INPUT 1....Bypass" menu appears on the front panel
display.
6. Use the and
"BYPASS" mode or "DSP" mode. Please note that if a particular input has
been set to digital coax or digital toslink, "NOT AVAILABLE" will appear
for this input as you cannot set the analog configuration of an input set to
digital.
7. Press the button on the remote when you have made a selection to move to the
next input. Repeat steps 6 and 7 for INPUT 2, INPUT 3, INPUT 4, INPUT 5,
INPUT 6, INPUT 7, INPUT 8, 7.1 INPUT and TUNER.
8. When you have finished setting the analog in configuration for all of the analog
inputs within your system, press the
press OK to return to the previous "SETUP MENU" to continue through the
system setup process, or simply press the SETUP button to exit the "SETUP
MENU" completely.
buttons on the remote to select the mode. You can select the
52
button on the remote to select BACK, then