Set Crossover Points - Cary Audio Design Cinema 12 Owner's Manual

MANUAL SOUND SETUP
4. Press the button on the remote until you reach "SET BALANCE" on the front
panel display. The "MOVIE SPK Setting / Set Balance" menu appears on the
front panel display.
5. Press the OK button on the remote to enter the "SET BALANCE" menu.
The "SET BALANCE / TEST MODE.....Off" menu appears on the front panel
display.
6. Select "AUTO" within the "TEST MODE" section of the "SET BALANCE"
menu.
When you select this function, the Cinema 12's test tone automatically cycles
every few seconds through all the speakers connected.
The unit cycles through the speakers in the following sequence:
FRONT LEFT > CENTER > FRONT RIGHT > SURROUND RIGHT >
SURROUND BACK RIGHT > SURROUND BACK LEFT > SURROUND
LEFT > SUBWOOFER
7. Use the and
You can adjust the selected channel level in 0.5dB steps across a range of -15dB
to +15dB. The unit will then resume cycling the Test Tone from speaker to
speaker.
8. When you have finished adjusting the levels for all of the speakers within your
system, press the
return to the previous "SETUP MENU" to continue through the system setup
process, or simply press the SETUP button to exit the "SETUP MENU"
completely.

SET CROSSOVER POINTS

The LPF/HPF (Low Pass Filter/High Pass Filter) Crossover menus are used to
independently set the internal High Pass filter of the Cinema 12 each of the speakers.
Setting the Speaker Crossover Points
In the Cinema 12, the Crossover Points can be selected in 10Hz increments within a 40Hz
to 150Hz range, or each speaker can be set to receive full range signal. Select the
crossover point closest to the low-frequency rating of the associated speaker. For
instance, set to FRONT L/R parameter to the crossover point closest to the low-frequency
rating of the front speaker.
Select the subwoofer crossover point equal to the lowest crossover point of the other
speakers.
buttons on the remote to adjust the speaker level.
button on the remote to select BACK, then press OK to
44