Power Control Connections; Remote Control; Power Connection - Cary Audio Design Cinema 12 Owner's Manual

INSTALLATION

POWER CONTROL CONNECTIONS

The TRIGGER jacks are used to remotely turn-on other devices in your system when the
Cinema 12 is powered ON. The 3 trigger jacks operate independently. Each trigger can
be set for off, or for zone 1 or zone 2.
We recommend that these jacks be used to turn on a power amplifier such as the Cary
Audio Model 7.125 or Model 7.250, but they may also be used to activate compatible
products such as projection screens, lights or blinds.
Connect a 3.5mm mono mini-plug between the Trigger jack on the rear panel of the
Cinema 12 and the low voltage trigger jack of the device to be controlled to enable
remote turn-on of that component. The zone 2 triggers will remain activated as long as
the Zone 2 Multi-room system is on, even when the Cinema 12 is in the Standby mode
for the main room.

REMOTE CONTROL

The IR INPUT jacks allow you to extend the on-board remote control sensor on the
Cinema 12 so that you may continue to control the Cinema 12 even when it is installed
behind solid or smoked cabinet doors or when the front panel sensor is otherwise not
visible to the remote control.
To extend the remote sensor of the Cinema 12's main zone, connect an optional remote
sensor to the IR INPUT 1 jack. The IR INPUT 2 jack is provided to enable remote
control of the Cinema 12's 2
Zone 2. Connect the sensor to the IR INPUT 2 jack using a 3.5 mm mono mini-plug and
the wiring specified by the sensor's manufacturer. (Many companies offer external IR
receivers for this purpose)

POWER CONNECTION

Insert the supplied power cord into the AC input on the rear panel of the processor.
Cables make a difference: We suggest that different AC power cables and various RCA
or XLR patch cables can and do influence the possible sound of a system. Consult your
dealer for advice about using different cables in your system.
CAUTION: Before you plug the power cord into an AC wall outlet, ensure all
connections to the processor have been made correctly.
WARNING: Never disconnect the power cord from the Cinema 12 while the
other end is plugged into an AC outlet. Doing so may cause an electric shock.
Always connect the power by plugging into the AC outlet last and disconnect
by unplugging from the AC outlet first.
nd
zone through the use of an optional remote sensor with
32