Amt Configuration - Nexcom NEX 883 User Manual

Chapter 3: Uefi Setup Utility
3.3.7 AMT Technology
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced
Intel AMT [Enabled]
BIOS Hotkey Pressed [Disabled]
MEBx Selection Screen [Disabled]
Hide Un-Configure ME Confirmation [Disabled]
MEBx Debug Message Output [Disabled]
Un-Configure ME [Disabled]
Amt Wait Timer 0
Disable ME [Disabled]
ASF [Enabled]
Activate Remote Assistance Process [Disabled]
USB Configure [Enabled]
PET Progress [Enabled]
AMT CIRA Timeout 0
WatchDog [Disabled]
OS Timer 0
BIOS Timer 0
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Intel AMT
Use this to enable or disable Intel(R) Active Management Technology BIOS
Extension. The default is [Enabled].
BIOS Hotkey Pressed
Use this to enable or disable BIOS hotkey press. The default is [Disabled].
MEBx Selection Screen
Use this to enable or disable MEBx Selection Screen. The default is
[Disabled].
Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved.
Hide Un-Configure ME Confirmation
Hide Un-Configure ME without password confirmation prompt. The
default is [Disabled].
MEBx Debug Message Output
Enable/Disable Intel (R)
Use this to enable or disable MEBx Debug Message Output. The default is
Active Management Technology
BIOS Extension.
[Disabled].
Note : iAMT H/W is always
enabled.
This option just controls the
Un-Configure ME
BIOS extension execution.
If enabled, this requires
additional firmware in the Un-Configure ME without password. The default is [Disabled].
SPI devic.
Amt Wait Timer
Set timer to wait before sending ASF_GET_BOOT_OPTIONS.
→←: Select Screen Disable ME
↑↓: Select Item
Enter: Select
Set ME to Soft Temporary Disabled. The default is [Disabled].
+/-: Change Opt.
F1: General Help
F7: Discard Changes
ASF
F9: Load UEFI Defaults
F10: Save & Exit
Use this to enable or disable Alert Specification Format. The default is
F12: Print Screen
ESC: Exit
[Enabled].
Activate Remote Assistance Process
Trigger CIRA boot. The default is [Disabled].
USB Configure
Use this to enable or disable USB Configure function. The default is
[Enabled].
PET Progress
User can enable or disable PET Events progress to receive PET events or
not. The default is [Enabled].
WatchDog
Use this to enable or disable WatchDog Timer. The default is [Disabled].
34
NEX 883 User Manual