Exit Screen - Nexcom NEX 883 User Manual

Chapter 3: Uefi Setup Utility

3.7 Exit Screen

In this section, you may set, change or clear the supervisor/ user password
for the system.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Main Advanced H/W Monitor
Save Changes and Exit
Discard Changes and Exit
Discard Changes
Load UEFI Defaults
Launch EFI Shell from filesystem device
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved.
Boot Security Exit
Exit system setup after saving
the changes.
F10 key can be used for this
operation.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F7: Discard Changes
F9: Load UEFI Defaults
F10: Save & Exit
F12: Print Screen
ESC: Exit
Save Changes and Exit
When you select this option, it will pop-out the following message,
"Save configuration changes and exit setup?" Select [OK] to save the
changes and exit the UEFI SETUP UTILITY.
Discard Changes and Exit
When you select this option, it will pop-out the following message,
"Discard changes and exit setup?" Select [OK] to exit the UEFI SETUP
UTILITY without saving any changes.
Discard Changes
When you select this option, it will pop-out the following message,
"Discard changes?" Select [OK] to discard all changes.
Load UEFI Defaults
Load UEFI default values for all the setup questions. F9 key can be used for
this operation.
Launch EFI Shell from filesystem device
Attempts to Launch EFI Shell application (Shell64.efi) from one of the available filesystem
devices.
41
NEX 883 User Manual